APPLICATION:
Temperature Sensor used with the Compool LX220/2TX or LX220/B solar control systems. This sensor may be used as a Water, or Solar sensor.
KIT INCLUDES:
QTY DESCRIPTION
--- ---------------------------
1 Temperature Sensor, 10K
2 Waterproof Crimp Connectors
1 Mounting Clamp
25 Feet 2-Conductor Wire
INSTALLATION:
Water Temperature Sensor
Select a convenient location to mount the Sensor between the filter pump and filter. Drill a 5/16 inch diameter hole in the pipe and insert the sensor. Position the hose clamp over the Sensor, and gently tighten around pipe. Caution Do not overtighten clamp.
Run a 2-conductor cable between the Sensor and the Power Center. At the Sensor, use crimp connectors (included) to provide waterproof connections. Before making connections, cut off stripped ends of cable. Insert the 2 wires to be connected into the connector and squeeze the connector with a pair of pliers. Caution Do not strip wires.
At the Power Center circuit board, connect Sensor wires to WATER screw terminals.
Solar Temperature Sensor
Do not use the clamp included with the sensor kit.
For unglazed panels, fasten Sensor next to solar panels. For glazed panels, suspend Sensor between collector and glazing.
Run a 2-conductor cable from the Sensor to the Power Center. At the Sensor, use crimp connectors (included) to provide waterproof connections. Before making connections, cut off stripped ends of cable. Insert the 2 wires to be connected into the connector and squeeze the connector with a pair of pliers. Caution Do not strip wires.
At the Power Center circuit board, connect Sensor wires to the SOLAR screw terminals.